|Questions about first pring [message #66375] Thu, 18 April 2013 19:33 UTC
Hey guys! |
This is the first time I'm considering printing something.
Actually I am considering two models but first I want to try with only one small prop.
Now, the models are done in Zbrush and they are from a few hundred polys up to a few millions.
I'm really confused about how to go about getting the models ready for printing. Does any one know where I can find really good info about how to use the 3d printing plug in from Zbrush? Or is there another program where I could make my object properly waterproofed and check for wholes?
Here is the model (prop) I'm talking about: http://p3d.in/oobiS/spin
Any help would be very much appreciated ...
P.s: I know how to read and I've found many good sources but I want to actually talk with people who done it before and tell me how everything worked for them and what I should be aware of.
Hope is ok!
Thanks for your patience!