Home » Community » 3D modeler needed » 3D Model from my brands logo.
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
icon4.gif  3D Model from my brands logo. [message #65935] Thu, 11 April 2013 00:58 UTC Go to next message
avatar tarabyakko  is currently offline tarabyakko
Messages: 4
Registered: December 2011
Go to all my models
Junior Member
Hi,

I would need a 3d modeller to create a 3d file from my brand's logo.
I have here attached a picture of it. It is the two Ks in the logo. It will be for a necklace so needs a little charm ring/hoop on the top in the middle.
I would need it in stainless steel, gold plated matte.
Measurements: 4mm high x 40mm length x 25mm width from the widest point.
In the picture the Ks of the logo are quite thin. They could be a bit "fatter".

Please leave me your sample screen caps and quotes.
Deadline is before mid may.

Thank you in advance !

Best,
Tara Byakko.

  • Attachment: logo.jpg
    (Size: 659.52KB, Downloaded 82 time(s))

Re: 3D Model from my brands logo. [message #65938 is a reply to message #65935 ] Thu, 11 April 2013 01:37 UTC Go to previous messageGo to next message
avatar solid_modeler  is currently offline solid_modeler
Messages: 20
Registered: September 2012
Go to my shop
Junior Member
I can have it done for 25$ in the next 24 hours if you can send me an Illustrator file of your logo (it would need to be exported as a DXF or DWG file)!

Email me at: solidmodelingdesigns@gmail.com if you would like to discuss it further!
Re: 3D Model from my brands logo. [message #65944 is a reply to message #65935 ] Thu, 11 April 2013 03:03 UTC Go to previous message
avatar UniverseBecoming  is currently offline UniverseBecoming
Messages: 754
Registered: March 2012
Go to my shop
Senior Member
Hi Tara,

I had a spare moment so I threw this together for you, see attached. They may reject it though cuz of thin walls. The walls cannot be made much thicker cuz doing so causes the overall design to be lost.

At 40 mm tall it ends up being about 17 mm wide.

Instead of attaching a bail at the top I drilled a through hole at the top instead. I did it this way cuz attaching a bail caused the kk to appear not as kk.

Whomever wants to rework this is free to do so. Smile

All the best,
James




I prefer to know nothing about everything rather than everything about nothing.  

James

 
   
Previous Topic:Rendering needed 4 tomorrow
Next Topic:Need Help Fixing Model Textures