Home » Community » It arrived! » Moldel wheels
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Moldel wheels [message #62616] Fri, 22 February 2013 19:36 UTC Go to next message
avatar Esoteric777  is currently offline Esoteric777
Messages: 15
Registered: May 2012
Go to my shop
Junior Member
only complaint is for a non locking assembly they shouldnt be glued, any way to split them without breaking?

http://i.imgur.com/NbYZy0q.jpg
http://i.imgur.com/1HHx8zV.jpg
http://i.imgur.com/URauOWp.jpg
http://i.imgur.com/CDSzyFs.jpg
Re: Moldel wheels [message #62618 is a reply to message #62616 ] Fri, 22 February 2013 19:45 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here
I'm confused by what you mean about the locking assembly?


The Mad Moder
michael@shapeways.com
Re: Moldel wheels [message #62621 is a reply to message #62618 ] Fri, 22 February 2013 20:16 UTC Go to previous messageGo to next message
avatar Esoteric777  is currently offline Esoteric777
Messages: 15
Registered: May 2012
Go to my shop
Junior Member
these werent designed to snap together, the outer ring is just supposed to lay on the face i did it to make it easier to clean the face before primer and paint.

[Updated on: Fri, 22 February 2013 20:17 UTC]

Re: Moldel wheels [message #62622 is a reply to message #62616 ] Fri, 22 February 2013 20:33 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here
Ah, so each piece is 3 pieces glued together, but were designed to snap together? Which material did you print in? Looks like FUD?


The Mad Moder
michael@shapeways.com
Re: Moldel wheels [message #62658 is a reply to message #62622 ] Sat, 23 February 2013 15:45 UTC Go to previous message
avatar Esoteric777  is currently offline Esoteric777
Messages: 15
Registered: May 2012
Go to my shop
Junior Member
Youknowwho4eva wrote on Fri, 22 February 2013 20:33

Ah, so each piece is 3 pieces glued together, but were designed to snap together? Which material did you print in? Looks like FUD?

these dont snap, i figured out my problem, from another builder.

 
   
Previous Topic:Gear and Slide by OSKAR
Next Topic:Half Mob-Tor