| Moldel wheels [message #62616] Fri, 22 February 2013 19:36 UTC |
 |
|
only complaint is for a non locking assembly they shouldnt be glued, any way to split them without breaking?
|
|
|
| Re: Moldel wheels [message #62618 is a reply to message #62616 ] Fri, 22 February 2013 19:45 UTC |
 |
|
I'm confused by what you mean about the locking assembly?
The Mad Moder
michael@shapeways.com
|
|
|
| Re: Moldel wheels [message #62621 is a reply to message #62618 ] Fri, 22 February 2013 20:16 UTC |
|
|
|
these werent designed to snap together, the outer ring is just supposed to lay on the face i did it to make it easier to clean the face before primer and paint.
[Updated on: Fri, 22 February 2013 20:17 UTC]
|
|
|
| Re: Moldel wheels [message #62622 is a reply to message #62616 ] Fri, 22 February 2013 20:33 UTC |
|
|
Ah, so each piece is 3 pieces glued together, but were designed to snap together? Which material did you print in? Looks like FUD?
The Mad Moder
michael@shapeways.com
|
|
|
| Re: Moldel wheels [message #62658 is a reply to message #62622 ] Sat, 23 February 2013 15:45 UTC |
|
|
| Youknowwho4eva wrote on Fri, 22 February 2013 20:33 |
Ah, so each piece is 3 pieces glued together, but were designed to snap together? Which material did you print in? Looks like FUD?
|
these dont snap, i figured out my problem, from another builder.
|
|
|
Search
