Home » Support » 3D Printing » Best cleaning methods
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Best cleaning methods [message #62141] Fri, 15 February 2013 20:33 UTC Go to next message
avatar cthagerthy  is currently offline cthagerthy
Messages: 5
Registered: January 2012
Go to all my models
Junior Member
Hello,

I've just received a moderately detailed model printed in frosted detail and it still has a bit of clinging unbonded plastic. I've blown off what i can with a canned air, but some remains, can i get this material wet? Will is cause any damage or warpage? any other ideas?

Thanks for any help!

-Chris
Re: Best cleaning methods [message #62143 is a reply to message #62141 ] Fri, 15 February 2013 20:40 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here
Here's a whole thread on cleaning methods.


The Mad Moder
michael@shapeways.com
Re: Best cleaning methods [message #62150 is a reply to message #62143 ] Fri, 15 February 2013 22:44 UTC Go to previous message
avatar cthagerthy  is currently offline cthagerthy
Messages: 5
Registered: January 2012
Go to all my models
Junior Member
thanks a lot! I searched for cleaning methods but came up with a lot of unrelated threads, i knew someone must have had this discussion already!

Thanks for the quick response!

-Chris

 
   
Previous Topic:the finish in black strong & flexible is similar to the other colors?
Next Topic:Is the stainless steel material magnetic?