Home » Support » 3D Design » ready for print my first parts
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
ready for print my first parts [message #61912] Tue, 12 February 2013 22:46 UTC Go to next message
avatar Anjys  is currently offline Anjys
Messages: 4
Registered: February 2012
Go to all my models
Junior Member
hi...
I'm just ready for to print same parts for to do same test...but I have a simple question:
How is the right orientation of the model?
the 'face' of the model must be in the bottom?
thanx
angelo
Re: ready for print my first parts [message #61920 is a reply to message #61912 ] Wed, 13 February 2013 02:11 UTC Go to previous messageGo to next message
avatar denali3ddesign  is currently offline denali3ddesign
Messages: 474
Registered: February 2011
Go to my shop
Senior Member
It doesn't matter. Currently Shapeways doesn't allow you to specify orientation. The printer operator chooses the orientation they think is best.


-Marcus
Re: ready for print my first parts [message #62013 is a reply to message #61920 ] Thu, 14 February 2013 08:56 UTC Go to previous message
avatar Anjys  is currently offline Anjys
Messages: 4
Registered: February 2012
Go to all my models
Junior Member
Thanx!Smile)

 
   
Previous Topic:multiple holes in silver
Next Topic:Programmable LED Lights?