Home » Community » General Discussion » Thoughts on 3D Scanners
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Thoughts on 3D Scanners [message #61281] Sun, 03 February 2013 20:25 UTC Go to next message
avatar JaceLightning  is currently offline JaceLightning
Messages: 1
Registered: February 2013
Go to all my models
Junior Member

3D Scanners[ 5 vote(s) ]
1.Own one and love it 1 / 20%
2.Own one but never use it 1 / 20%
3.123D and Dave 3D are good enough for me 0 / 0%
4.Would own one, but they are two exspensive 2 / 40%
5.Would own one, but scanning requires too much manual work 1 / 20%
6.Would own one, but they only scan outside features, and not inner features like gears/electronics 0 / 0%
7.I just enjoy printing and not designing 0 / 0%

Hey guys. Just trying to get feedback on 3D scanners. Do they work? Do you like them?

I know some require a lot of manual setup and work, like filling in holes, rotating the object by hand. Most require the object to be reflective and detailed, i.e. if the object is black, shinny, or has no features, it might be hard for the program to reconstruct the geometry.

3D scanners are great for shapes that are convex, but what about shapes with deep holes? or what about seeing inside the object? Wouldn't it be nice to scan an assembled object and then print a copy assembled?

Re: Thoughts on 3D Scanners [message #61560 is a reply to message #61281 ] Fri, 08 February 2013 03:38 UTC Go to previous messageGo to next message
avatar NormL  is currently offline NormL
Messages: 33
Registered: March 2012
Go to my shop
Member
I actually have three scanners. They are all a little larger than you are thinking of. Two are time of flight and have an effect range of 350 feet and one phased based that is more of a below 75 feet machine. I love working with them, but, I too want a smaller one for playing with.
Re: Thoughts on 3D Scanners [message #61562 is a reply to message #61560 ] Fri, 08 February 2013 04:16 UTC Go to previous message
avatar PeregrineStudios  is currently offline PeregrineStudios
Messages: 322
Registered: September 2012
Go to my shop
Senior Member
Missed a category: Don't own one, but am currently saving to buy one. Just going with the lower-end at the get-go, the Solidoodle 3 - I'll see how much I use it and decide from there if I'm going to get a fancier one.


EDIT: D'oh - 3D SCANNERS, not 3D Printers. Heh-heh! My bad.

[Updated on: Fri, 08 February 2013 04:41 UTC]


 
   
Previous Topic:Flexibility of WSF
Next Topic:Community Journal #2 Published

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.