Home » Community » 3D modeler needed » Roses
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Roses [message #60380] Fri, 18 January 2013 04:05 UTC Go to next message
avatar Jeff13  is currently offline Jeff13
Messages: 1
Registered: January 2013
Go to all my models
Junior Member
I have an established business where I know I could sell a large volume of "WOW" roses. I've known about 3-D printing for awhile and figured I'd wait until prices of equipment dropped so I could buy my own. I just now found out about Shapeways in this month's Entrepreneur magazine and now don't think I need to own the equipment. BUT, I need a designer. I don't want to give too much input into how I personally see the creations, but would rather see what you bring to the table. Myself I could start with a rose that looks very "lacy". I'll be spending some time tomorrow reading every word on the Shapeways website. I'd also prefer a designer who is VERY familiar with Shapeways and VERY familiar with using the materials available.

G'nite
Jeff

UPDATE: I have found and hired my designer - so excited!

[Updated on: Sun, 27 January 2013 16:21 UTC]

Re: Roses [message #60406 is a reply to message #60380 ] Fri, 18 January 2013 20:52 UTC Go to previous message
avatar JACANT  is currently offline JACANT
Messages: 543
Registered: July 2011
Go to my shop
Senior Member
http://www.shapeways.com/model/652208/nylander-rose-2-inch-d iameter-solid.html

http://www.shapeways.com/forum/index.php?t=ppost&toi=732 90&back_to_model=http://www.shapeways.com/model/652208/n ylander-rose-2-inch-diameter-solid.html?li=send_message

[Updated on: Fri, 18 January 2013 20:54 UTC]


jacantdesign@gmail.com

 
   
Previous Topic:-
Next Topic:3D modeler needed for Acer Liquid Glow case