Home » Community » General Discussion » Lightweight and waterproof chasis, possible with 3D?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Lightweight and waterproof chasis, possible with 3D? [message #60288] Wed, 16 January 2013 09:02 UTC
avatar Kordian  is currently offline Kordian
Messages: 1
Registered: January 2013
Go to all my models
Junior Member
Hello everybody,
I am new to the community and interested in the 3D subject.
I need to build a chasis with the dimentions of 60x30x15mm. It will be used outside and should provide protection against humidity from the outside. My question is: is it possible to manufacture such a chasis within 5g of weight?
Thanks in advance for any response.
Regards
Kordian

 
   
Previous Topic:New Plastic Colours?
Next Topic:The 3D4D Challenge