|
| Re: Very disappointed with my latest prints. [message #60043 is a reply to message #60042 ] Fri, 11 January 2013 18:08 UTC |
  |
|
Hopefully you have already emailed service? If not, do that, as those prints don't look good.
The Mad Moder
michael@shapeways.com
|
|
|
| Re: Very disappointed with my latest prints. [message #60044 is a reply to message #60043 ] Fri, 11 January 2013 18:48 UTC |
|
|
@Youknowwho4eva, Thanks, I've just sent them a message. We'll see if I can get this resolved. 
|
|
|
| Re: Very disappointed with my latest prints. [message #60045 is a reply to message #60044 ] Fri, 11 January 2013 19:03 UTC |
|
|
On the cocker spaniel, where you say there is a chunk missing.. that appears to be missing from the default Shapeways render as well. Is it possible that the area was a separate shell? In particular, if you have a shell with inverted normals, it may display properly in your editor, but MeshMedic is going to remove that shell.
I'm not saying that it happened in this case, but you should always take a close look at the default Shapeways render.. if it's not right, then you can't assume the print be correct.
Patience, Persistance, Politeness - the 3Ps will help us get us to Perfect Printed Products
|
|
|
| Re: Very disappointed with my latest prints. [message #60059 is a reply to message #60045 ] Fri, 11 January 2013 23:04 UTC |
|
|
@stonysmith, Yes I've checked the original model and it appears that there is a depression there, so that kinda explains the front and will have to be remodeled. But as for the rear of the pendant it is messed up. And I believe that with the others, shouldn't have left the "factory of the future" in that state. As you can see the cufflink is all bent and misshapen with very visible print lines which I did not expect for fine detail. The ring also has one side of the ring band bent out of shape too when compared to the good side. I just think that whom ever was on quality control that day took the day off! 
|
|
|
| Re: Very disappointed with my latest prints. [message #60263 is a reply to message #60059 ] Tue, 15 January 2013 16:20 UTC |
|
|
Thought I'd post an update.... Shapeways has offered to reprint these for me  So I'll find out on the 25th of Jan if they'll be better printed. Here's hoping for the best. 
|
|
|
|
| Re: Now very happy with my prints. [message #65464 is a reply to message #60568 ] Thu, 04 April 2013 02:35 UTC |
|
|
Love the dog print. Can you please advise how you modeled that item? What SW?
the Fabled Santa
http://www.FabledSanta.com
|
|
|
Search
See attached pics.
