Home » Community » General Discussion » Material for buttons
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Material for buttons [message #60109] Sun, 13 January 2013 01:41 UTC Go to next message
avatar Spooky_Bulldog  is currently offline Spooky_Bulldog
Messages: 11
Registered: October 2012
Go to my shop
Junior Member
Hi all,
I've seen some 3d printed buttons here and there and was wondering,
which material would be suitable for buttons.
Buttons goes through hot water wash and dry machines all the time. So is there any material provided here which could endure such process?
Thank you.

Re: Material for buttons [message #60185 is a reply to message #60109 ] Mon, 14 January 2013 13:53 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5734
Registered: September 2008
Go to my shop
Shapie Expert
I work here
I think the "best" material would be Nylon, or WSF as we call it. But check out the material page for the constraints of each material.


I learned a long time ago the wisest thing I can do is be on my own side, be an advocate for myself and others like me. -Maya Angelou
michael@shapeways.com Community Advocate

 
   
Previous Topic:Obtaining the dyed WSF pieces without polishing?
Next Topic:3D Design Exhibit: Call for Entries!

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.