Home » Community » It arrived! » 3-d Printed Bonsai pot
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
3-d Printed Bonsai pot [message #58626] Fri, 14 December 2012 18:53 UTC Go to next message
avatar bluelinegecko  is currently offline bluelinegecko
Messages: 79
Registered: February 2011
Go to my shop
Member
I'm sure I'm not even close to the first person to do this. But while I've seen a few 3-D models in the galleries I have yet to see one anyone printed off. Now that Shapeways added more glaze color options I decided to order one. I got this one delivered yesterday. This was a last minute addition to an order I placed right before the "black Friday" sales deadline and was an unfinished model I made some time ago just to get a price quote and didn't put the finishing touches on it. There is some unevenness in the glazing that was likely due to the fact that my model has several sharp edges that weren't radiused and smoothed. I like the eggshell blue color but think that black or green would have been a better choice for this model. Overall I am very happy with how it tuned out though. While the cost is not very economical yet for larger scale pots, it's an option smaller "mame" (small) sized bonsai.

index.php?t=getfile&id=24359&private=0
index.php?t=getfile&id=24360&private=0


There is some debate over whether a glazed interior pot surface is detrimental to the health of plants. I'm of the school that it is not. I do however plan to make a few changes to the design including sloping the interior floor towards the drain holes to increase drainage, smoothing the edges, and adding some very slight "friction ridges" to the interior sides of the pot to help lock the tree and soil in the pot. I don''t have a tree ready for the pot right now, but I I think I'm going to put a seedling in it and place it outside for the winter to make sure it can withstand the freeze/thaw cycles outside.

[Updated on: Fri, 14 December 2012 18:55 UTC]

Re: 3-d Printed Bonsai pot [message #58715 is a reply to message #58626 ] Mon, 17 December 2012 03:35 UTC Go to previous messageGo to next message
avatar Ray716  is currently offline Ray716
Messages: 227
Registered: August 2010
Go to my shop
Senior Member
Amazing and a fantastic idea!!! I can't wait to see it with a Bonsai set up in it.

Ray


www.RayTomlinDesigns.com
Re: 3-d Printed Bonsai pot [message #58729 is a reply to message #58715 ] Mon, 17 December 2012 10:38 UTC Go to previous message
avatar bartv  is currently offline bartv
Messages: 1670
Registered: December 2007
Go to my shop
Senior Member
Sweet! Waiting for pic with bonsai +1! Wink


Community Manager Europe | Shapeways

 
   
Previous Topic:MV Loch Linnhe car ferry
Next Topic:Whoo Hoo & Boo Hoo