Home » Community » General Discussion » SolidWorks texture
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
SolidWorks texture [message #58429] Tue, 11 December 2012 22:46 UTC Go to next message
avatar lemire182  is currently offline lemire182
Messages: 5
Registered: July 2012
Go to my shop
Junior Member
Hi shapeways,

Can anyone help me, I can't seem to get an image ''stuck'' as a texture on my parts in Solidworks.

I just want to extrude an image to get a 3mm thick piece in full-color sandstone. Can it be done in Solidworks?

thanks in advance,

Anthony Lemire

Re: SolidWorks texture [message #58477 is a reply to message #58429 ] Wed, 12 December 2012 16:12 UTC Go to previous message
avatar jelloslug  is currently offline jelloslug
Messages: 2
Registered: February 2012
Go to all my models
Junior Member
You can apply the pic as a decal but I don't think that's actually what you want. You probably want to make the pic an appearence and then map it using "projection"

 
   
Previous Topic:Modeler
Next Topic:Precious metal laser sintering