Home »  » 3D Design » Ordering several prototype parts
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Ordering several prototype parts [message #5814] Wed, 12 August 2009 22:37 UTC Go to next message
avatar B1lancer  is currently offline B1lancer
Messages: 117
Registered: May 2009
Go to my shop
Senior Member
I am planning to produce several parts which are a bit of an experiment.
My question is if I order several parts and one fails to print does the order
get cancelled? Or will it be dispatched with just the parts that will print?

Thanks for any help,

Regards, Jack
Re: Ordering several prototype parts [message #5816 is a reply to message #5814 ] Wed, 12 August 2009 23:15 UTC Go to previous message
avatar WiKKiDWidgets  is currently offline WiKKiDWidgets
Messages: 224
Registered: April 2009
Go to my shop
Senior Member
If all the separate parts are part of one print job. I.e. all the parts are intended to print at one time and one is too thin or non-manifod, the entire job gets canceled. If you place an order with all the parts as separate objects intending to be printed separately, then if one of them cannont be printed, only that one will be cancled and all the other will be printed.

 
   
Previous Topic:3d models on paper
Next Topic:Hard/Smooth edges ?

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.