| Successful upload shows up as unprintable [message #57710] Fri, 30 November 2012 00:18 UTC |
 |
|
Created these models in 1/1 scale with Sketchup, resized them to 1/144, exported as .stl, fixed them with netfabb and uploaded them successfully. Prices showed up, even got a couple of orders:
http://www.shapeways.com/model/802251/berlin-flak-tower-ammu nition-lift-type-ii-1-144.html?li=my-models
http://www.shapeways.com/model/802151/berlin-flak-tower-ammu nition-lift-type-i-1-144.html?li=my-models
Using the same sketchup file in 1/1 scale, I resized it to 1/72 scale (and 1/35 scale, with the same end results), exported as .stl, fixed it with netfabb and uploaded both successfully (according to the two emails after the upload). However they dont show up in my shop or model section. I can get to them by following the link received by email ("Your product, 'pequeno 72 (repaired)' is now available on Shapeways.com, where you can make it ready for prime time: pequeno 72 (repaired)").
http://www.shapeways.com/model/804589
http://www.shapeways.com/model/804578
...and they show up as unprintable? Howcome?
Thank you,
Francisco
http://fbminis.blogspot.com/
http://fbminisworkbench.blogspot.com/
|
|
|
|
| Re: Successful upload shows up as unprintable [message #57713 is a reply to message #57712 ] Fri, 30 November 2012 01:11 UTC |
 |
|
I didn't. Maybe it was a "glitch in the Matrix" 
Thank you for your time,
Francisco
http://fbminis.blogspot.com/
http://fbminisworkbench.blogspot.com/
|
|
|
Search
