Home » Community » 3D modelers for hire » Gear ring, stirring weel, bike pedal weel: Who wants to make it?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Gear ring, stirring weel, bike pedal weel: Who wants to make it? [message #57152] Tue, 20 November 2012 14:42 UTC Go to next message
avatar teofend  is currently offline teofend
Messages: 1
Registered: November 2012
Go to all my models
Junior Member
Hello,

who can make me 3d modelsof these, what would you need for this and how much would it cost?

Gear 5TH 25 teeth Transmission T-5
-> has to be fit to run in a car engine
http://imageshack.us/photo/my-images/15/gearkw.jpg/

Stirring weel
->For a car.
http://imageshack.us/photo/my-images/706/carstirringweel.jpg /

SRAM Bike pedal weel Apex, black, 175mm, 46-38T, 401000279
http://imageshack.us/photo/my-images/856/bikeh.jpg/

Thanks!
Re: Gear ring, stirring weel, bike pedal weel: Who wants to make it? [message #57231 is a reply to message #57152 ] Wed, 21 November 2012 12:29 UTC Go to previous message
avatar bartv  is currently offline bartv
Messages: 1668
Registered: December 2007
Go to my shop
Shapie Expert
teofend wrote on Tue, 20 November 2012 14:42

Gear 5TH 25 teeth Transmission T-5
-> has to be fit to run in a car engine
http://imageshack.us/photo/my-images/15/gearkw.jpg/


I'll need to insert a warning here: our steel quality is not certified to be used as a mechanical part in an engine - it would be dangerous to use it!

Bart


Community Manager Europe | Shapeways

 
   
Previous Topic:Cheap Designer For hire
Next Topic:Advanced Mechanical Modeler

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.