| Modeler needed for simple pendant model to be created [message #56623] Sun, 11 November 2012 00:48 UTC |
 |
|
Hello. I am looking to recreate this pendant.I would like to print it in stainless or a similar heavy metal. If the lines of the squared shapes of the tile can be etched in I can enamel the "stone" faces. It wold measure 3.5cm long. Flat top would be 1.5cm. Flat bottom 1cm. Slanted sides are also 3.5. Any help would be appreciated. If you have Silence of the Lambs on DvD you can get a good glimpse of it 
Attachment: silence.jpg
(Size: 71.76KB, Downloaded 80 time(s))
[Updated on: Sun, 11 November 2012 07:14 UTC]
|
|
|
| Re: Modeler needed for simple pendant model to be created [message #56645 is a reply to message #56623 ] Sun, 11 November 2012 22:33 UTC |
 |
|
|
PM Sent
|
|
|
Search
