Home » Community » General Discussion » Wire tests
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Wire tests [message #56416] Wed, 07 November 2012 04:56 UTC
avatar Anthromod  is currently offline Anthromod
Messages: 12
Registered: May 2011
Go to my shop
Junior Member
Hi. I'm currently working on a robot hand and I'm interested in if anyone tested the strengths of wires printed in Strong and flexible?

I have a design that uses 4-3mm wires, and a Theo Jansen model that are approx 1.8mm, but that is rather hard to test without breaking. Does anyone have experience using approx 2mm wires, for push/pull uses?

Oh whilst I'm asking, anyone have practical experience of designing living hinges?

 
   
Previous Topic:Compenetrating geometry?
Next Topic:Dilbert does 3d printing, pure win!!!