Home » Community » Work in progress » Cantilever signal bridge
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Cantilever signal bridge [message #55851] Wed, 24 October 2012 14:28 UTC Go to next message
avatar robinkloet is currently offline robinkloet
Messages: 3
Registered: October 2012
Go to all my models
Junior Member
Hey there,

I got some questions to ask about a model I wanna make.
Its a HO signal bridge and my problem is that the picture isnt fully strait taken how can it be solved?
I cant use the blue line to straiten it up so. Who can help me?

Greetings,

Robin

Report message to a moderator
Re: Cantilever signal bridge [message #55857 is a reply to message #55851 ] Wed, 24 October 2012 15:08 UTC Go to previous messageGo to next message
avatar stonysmith is currently offline stonysmith
Messages: 1037
Registered: August 2008
Go to my shop
Senior Member
moderator
What blue line?

What program are you using to build the model? Or, are you asking to straighten the photograph itself?

Patience, Persistance, Politeness - the 3Ps will help us get us to Perfect Printed Products
Report message to a moderator
Re: Cantilever signal bridge [message #55860 is a reply to message #55857 ] Wed, 24 October 2012 15:30 UTC Go to previous messageGo to next message
avatar robinkloet is currently offline robinkloet
Messages: 3
Registered: October 2012
Go to all my models
Junior Member
Oh, yes sorry.

I use the sketchup and I my photograph is a little twisted as I aligne it along the blue vertical line.
It looks like the photo hasn´t been taken straight. I would I be able to fix that?

Robin
Report message to a moderator
Re: Cantilever signal bridge [message #55896 is a reply to message #55860 ] Wed, 24 October 2012 23:03 UTC Go to previous messageGo to next message
avatar bvr is currently offline bvr
Messages: 107
Registered: November 2010
Go to my shop
Senior Member
Actually, it's not too difficult to correct perspective in a photograph.
See here.
http://hugin.sourceforge.net/tutorials/surveying/en.shtml
bvr

ps. I hope I understood correctly.

oops, edit;
it should've been this link
http://hugin.sourceforge.net/tutorials/perspective/en.shtml
it's basically the same procedure but the first link works for 3 dimensions. This one is for correcting in 2 dimensions.

[Updated on: Thu, 25 October 2012 09:33 UTC]

Buffalo, 360° @ a time
Report message to a moderator
Re: Cantilever signal bridge [message #55907 is a reply to message #55896 ] Thu, 25 October 2012 09:03 UTC Go to previous message
avatar robinkloet is currently offline robinkloet
Messages: 3
Registered: October 2012
Go to all my models
Junior Member
Thanks bvr,

That was just what I was looking for.

Robin
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:My Sisters getting married!
Next Topic:A strategy for a check-print?