Home » Community » 3D modeler needed » Modeler wanted for 12cm Pony Figure
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Modeler wanted for 12cm Pony Figure [message #55620] Thu, 18 October 2012 20:46 UTC Go to next message
avatar RehydratedFruit  is currently offline RehydratedFruit
Messages: 1
Registered: October 2012
Go to all my models
Junior Member

I'm looking for a modeler to design a full colour 12cm sandstone model from the picture attached.
The model would be that pony in that pose, I have other pictures for references too.
If you are interested please estimate a cost which includes the cost of construction and how long it would take.
I will have a look through your previous work as references.



Re: Modeler wanted for 12cm Pony Figure [message #55633 is a reply to message #55620 ] Fri, 19 October 2012 01:51 UTC Go to previous message
avatar Ming  is currently offline Ming
Messages: 101
Registered: May 2009
Go to all my models
Senior Member
i'm a 3d modeler for over 15 years and have don tons of similar over the years .
i can model almost anything similarly based on references provided Smile
you may view my works at my website :

http://www.its-ming.com/2000/html2000/portfolio2005/main.htm l

if interested, please email to my personal email add as i don't check this site mail often Smile
email : ming@its-ming.com


Previous Topic: Wanted: Mechanical Engineering Modeler
Next Topic:looking for cad designer