Now Through Sunday Night. Black Friday Deals & Free Shipping! See the deals.
Home » Community » 3D modeler needed » Nintendo Controller Cut ups
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Nintendo Controller Cut ups [message #54243] Wed, 19 September 2012 04:39 UTC Go to next message
avatar Raizer04  is currently offline Raizer04
Messages: 24
Registered: September 2012
Go to my shop
Junior Member
Hey there, can someone help a struggling person out???

I have a basic nintendo controller that I am trying to print in specific pieces.

I have a full scaled (at least it says it is...) nintendo controller in .STL

-I need the D-pad (and underside) made into an .STL by itself (I also need an STL of the button itself)

-I need the A/B buttons (of the nintendo controller) (and the underside) By itself angled like in the picture. (I also need an STL of the button itself)

-I need the A/B buttons again (of the nintendo controller) (and the underside) By itself angled with 4 of them

So in total I just need 5 seperate files. The Dpad, the dpad button, the A/B section, the A/B section button, and the 4 button configuration. (the A/B button is the same button for the 4 button configuration).

*I have the STL of the nintendo controller attached to make everything easier

Pics of the layout:

D-pad: http://i47.tinypic.com/2s1lzps.jpg

A/B buttons: http://i47.tinypic.com/r856jc.jpg

C-buttons: http://i50.tinypic.com/209ge3c.jpg

email: raizer012345@yahoo.com

Re: Nintendo Controller Cut ups [message #54330 is a reply to message #54243 ] Fri, 21 September 2012 10:33 UTC Go to previous message
avatar TechyBen  is currently offline TechyBen
Messages: 26
Registered: September 2011
Go to my shop
Junior Member
If you would like to PM me with the details, I could have a look at making up an STL with the measurements today. Smile
Hope your project goes well!

[edit]
Here is an example of one for you.

http://www.shapeways.com/model/708996/a2cfabe9a4b04f67b99e31 3d3763ee97

[Updated on: Fri, 21 September 2012 13:27 UTC]


 
   
Previous Topic:Who wants to help make a Lantern??
Next Topic:Looking for 3D modeler who likes N-scale

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.