Home » Community » 3D modeler needed » Nintendo Controller Cut ups
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Nintendo Controller Cut ups [message #54243] Wed, 19 September 2012 04:39 UTC Go to next message
avatar Raizer04  is currently offline Raizer04
Messages: 24
Registered: September 2012
Go to my shop
Junior Member
Hey there, can someone help a struggling person out???

I have a basic nintendo controller that I am trying to print in specific pieces.

I have a full scaled (at least it says it is...) nintendo controller in .STL

-I need the D-pad (and underside) made into an .STL by itself (I also need an STL of the button itself)

-I need the A/B buttons (of the nintendo controller) (and the underside) By itself angled like in the picture. (I also need an STL of the button itself)

-I need the A/B buttons again (of the nintendo controller) (and the underside) By itself angled with 4 of them

So in total I just need 5 seperate files. The Dpad, the dpad button, the A/B section, the A/B section button, and the 4 button configuration. (the A/B button is the same button for the 4 button configuration).

*I have the STL of the nintendo controller attached to make everything easier

Pics of the layout:

D-pad: http://i47.tinypic.com/2s1lzps.jpg

A/B buttons: http://i47.tinypic.com/r856jc.jpg

C-buttons: http://i50.tinypic.com/209ge3c.jpg

email: raizer012345@yahoo.com

Re: Nintendo Controller Cut ups [message #54330 is a reply to message #54243 ] Fri, 21 September 2012 10:33 UTC Go to previous message
avatar TechyBen  is currently offline TechyBen
Messages: 26
Registered: September 2011
Go to my shop
Junior Member
If you would like to PM me with the details, I could have a look at making up an STL with the measurements today. Smile
Hope your project goes well!

[edit]
Here is an example of one for you.

http://www.shapeways.com/model/708996/a2cfabe9a4b04f67b99e31 3d3763ee97

[Updated on: Fri, 21 September 2012 13:27 UTC]


 
   
Previous Topic:Who wants to help make a Lantern??
Next Topic:Looking for 3D modeler who likes N-scale