Just got these Friday. The detail is really quite good and these would be perfect if not for the frosting in the support areas. However on the larger figure the support residue is so slight it cleaned up very good.

Very slight signs of register marks.
The 1:20 scale one did not fair as well.

Those marks look almost like giant zits on his face and will have to be leveled off.
I'm not sure why they supported this model which is just a rescaled model of the larger figure on it's face. The face is and all the detail on the front is the hardest to clean up and level off. This is where I really get frustrated with their consistency.
On the other hand...

That little cross with the letter c on it is a 7/8ths scale replica of the same ornament on the end of Cy Crumley's watch chain. The entire ornament is just about 1/16th of an inch tall. I'm very pleased with how the 7/8ths scale figure turned out and even the 1:32 one isn't too bad.

I just wish they would support all the models on the least detailed side so they aren't so difficult to smooth and level out.

• Attachment: figures91312sm.jpg
  (Size: 210.43KB, Downloaded 369 time(s))

• Attachment: cySEclosegoodsidesm.jpg
  (Size: 244.05KB, Downloaded 371 time(s))

• Attachment: cy120primedclose.jpg
  (Size: 153.30KB, Downloaded 368 time(s))

• Attachment: cySEprclosefobsm.jpg
  (Size: 100.19KB, Downloaded 367 time(s))

• Attachment: arab-3close.jpg
  (Size: 77.56KB, Downloaded 366 time(s))

[Updated on: Sun, 16 September 2012 22:21 UTC]