Home » Community » It arrived! » Swiss Army Knife Sides
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Swiss Army Knife Sides [message #53483] Sat, 01 September 2012 19:56 UTC
avatar eNonsense is currently offline eNonsense
Messages: 19
Registered: June 2012
Go to my shop
Junior Member
I just got my first set of non-test 3D prints a couple days ago.

They are replacement scales/sides for a small Swiss Army Knife.

http://i.imgur.com/T1Iuc.jpg
http://i.imgur.com/E1Tzr.jpg

I just put them up in my store. So awesome!

http://www.shapeways.com/shops/electronicnonsense

Very Happy
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Good Neighbours Cube by OSKAR
Next Topic:thin layered 'lilly pendant' succeeded