Home » Support » 3D Printing » Adhesives for FUD
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Adhesives for FUD [message #53058] Fri, 24 August 2012 03:46 UTC Go to next message
avatar Phxman is currently offline Phxman
Messages: 84
Registered: June 2012
Go to all my models
Member
What adhesives do you advise for FUD?

Is there a solvent for bonding?

There have been various suggestions elsewhere,
but not from Shapeways, who would have the suppliers
full spec'.
Report message to a moderator
Re: Adhesives for FUD [message #53234 is a reply to message #53058 ] Mon, 27 August 2012 20:21 UTC Go to previous messageGo to next message
avatar GWMT is currently offline GWMT
Messages: 192
Registered: February 2011
Go to my shop
Senior Member
I use ACC/Krazy Glue on FUD.
Report message to a moderator
Re: Adhesives for FUD [message #53242 is a reply to message #53234 ] Mon, 27 August 2012 22:52 UTC Go to previous message
avatar Phxman is currently offline Phxman
Messages: 84
Registered: June 2012
Go to all my models
Member
Thank you - I have been told something like this before; but is it the correct adhesive.
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Combining Parts, White strong flexible
Next Topic:Unglazed Ceramic