| Modeler for a stamp needed [message #53016] Thu, 23 August 2012 07:01 UTC |
 |
|
Hi at all,
I just happend to find this really nice website today, which could be the solution to what I am looking for.
I am in need of two stamps (one should be approximately 10cm and the other one 4cm wide - the logo). So it is basically one stamp in two sizes.
The stamp design itself is not of any importants, it just has to be stable, because I need the stamp to hammer the logo into leather.
Some like this would be way more than I need:
http://www.shapeways.com/model/191260/peter-stamp.html
The only thing I basically care about is that the logo (which is just 4 letters and two arrows) log like they do on the leather, as they do on the paper, if I hammer the logo onto the leather.
Is there anyone, who could help me with that? and how expensive would that possibly be?
I am just a student doing some designs in my spare time, so if it is going to be expensive, I won't be able to do it anyhow.
Thanks in advance!
I can provide my logo to anyone asking, but don't wanna show it publicly, since it is just for my personal works.
Cheers,
Pose
|
|
|
| Re: Modeler for a stamp needed [message #53032 is a reply to message #53016 ] Thu, 23 August 2012 13:48 UTC |
 |
|
Afternoon Pose, I can quickly model you what you need and upload it on here to give you a quote. Won't take long at all and I wont charge, feel free to send me a private message with your logo and the size you want and I'll get on it right away.
www.modelsbymarsden.com
|
|
|
| Re: Modeler for a stamp needed [message #53073 is a reply to message #53032 ] Fri, 24 August 2012 13:22 UTC |
|
|
Thank you Modelsbymarsden!
You did a wonderful job and helped me out really quickly!
I strongly recommend Marsden's work to everyone!
|
|
|
Search
