Home » Community » General Discussion » 3D-Ring sizes chart stl-file
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
3D-Ring sizes chart stl-file [message #52208] Wed, 01 August 2012 16:30 UTC Go to next message
avatar Eeppium  is currently offline Eeppium
Messages: 133
Registered: May 2009
Go to my shop
Senior Member
Hi all. =)

just wanted to share this ring chart wich I just completed.
This should help the ring scaling quite a bit.
I´ve measured them on netfabb and they seem to be accurate.
share and use at your will.

I used this chart as a base Link


(edit: oops saved with wrong file name) Rolling Eyes

[Updated on: Wed, 01 August 2012 16:36 UTC]

Re: 3D-Ring sizes chart stl-file [message #52209 is a reply to message #52208 ] Wed, 01 August 2012 16:37 UTC Go to previous messageGo to next message
avatar virtox  is currently offline virtox
Messages: 1141
Registered: August 2008
Go to my shop
Senior Member
moderator
Awesome! Very useful! Nod
Especially the combined US/EU combined sizing!

Thanks for sharing!

Cheers,

Stijn


- Artist / Engineer / Designer / Shopowner / Volunteer / Moderator -
Re: 3D-Ring sizes chart stl-file [message #52316 is a reply to message #52209 ] Mon, 06 August 2012 08:49 UTC Go to previous messageGo to next message
avatar Stanleys  is currently offline Stanleys
Messages: 3
Registered: August 2012
Go to all my models
Junior Member
Very beautiful designs for the person wearing it and it also gives much attention in creating the best designs.
Re: 3D-Ring sizes chart stl-file [message #52345 is a reply to message #52208 ] Tue, 07 August 2012 12:10 UTC Go to previous messageGo to next message
avatar Mezmera  is currently offline Mezmera
Messages: 41
Registered: June 2012
Go to my shop
Member
Nice! Thanks for sharing this.
Re: 3D-Ring sizes chart stl-file [message #52346 is a reply to message #52345 ] Tue, 07 August 2012 12:23 UTC Go to previous message
avatar Eeppium  is currently offline Eeppium
Messages: 133
Registered: May 2009
Go to my shop
Senior Member
No problem Cool

It´s so much easier just to scale the rings to fit the cylinders, than measuring them.

 
   
Previous Topic:3-d scanning & printing?
Next Topic:Honeycomb