| Worm gear needed - see technical drawing [message #52009] Fri, 27 July 2012 23:51 UTC |
|
|
Hello all,
I'm very new to this whole 3d printing thing, but I'm betting it will work for a particular part I need replaced in a vintage Bodine motor. The right angle worm gear was mashed on 3 teeth and I found an original technical drawing that gives every detail needed. I'm curious if I could convince someone to give this a shot for me? I can tap the set screw holes if printing threads is not easy. See drawing.
Attachment: 25815474.jpg
(Size: 1.45MB, Downloaded 91 time(s))
|
|
|
Search
