Home » Community » 3D modeler needed » Ring Design
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Ring Design [message #51860] Wed, 25 July 2012 17:23 UTC Go to next message
avatar cabalm27 is currently offline cabalm27
Messages: 4
Registered: May 2012
Go to all my models
Junior Member
Would you be able to make a ring based off of this design?

What would the pricing be?

Thanks.

Report message to a moderator
Re: Кольцо Дизайн [message #51914 is a reply to message #51860 ] Thu, 26 July 2012 15:14 UTC Go to previous messageGo to next message
avatar andrey2074 is currently offline andrey2074
Messages: 1
Registered: September 2010
Go to my shop
Junior Member
Hello.


I have experience in the construction bas-relief , jewelry , and the preparation of the file to print.
Look PM


Thank You

Andrey.

[Updated on: Thu, 26 July 2012 15:22 UTC]

Report message to a moderator
Re: Ring Design [message #51938 is a reply to message #51860 ] Thu, 26 July 2012 21:04 UTC Go to previous message
avatar njcadman is currently offline njcadman
Messages: 6
Registered: July 2012
Go to all my models
Junior Member
Can you make a better picture?
What ring size, metal?

I make rings all the time.
Check my website:
www.jewelryboxonline.com
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:detailed Pen Clip
Next Topic:3d model needs a small fix.