Home » Community » Work in progress » Rectangular Sake & Espresso Tower Cup
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Rectangular Sake & Espresso Tower Cup [message #51521] Wed, 18 July 2012 12:50 UTC Go to next message
avatar opresco is currently offline opresco
Messages: 165
Registered: April 2010
Go to my shop
Senior Member
index.php?t=getfile&id=18637&private=0

Rectangular Sake & Espresso Tower Cup
http://shpws.me/aMuH


cascador
Report message to a moderator
Re: Rectangular Sake & Espresso Tower Cup [message #51780 is a reply to message #51521 ] Tue, 24 July 2012 14:55 UTC Go to previous messageGo to next message
avatar jeff is currently offline jeff
Messages: 317
Registered: July 2008
Go to my shop
Senior Member
what's the diameter of the skinniest part of the legs where they connect to the cup? I think this would print alright if they are 3mm or wider.

This is my fav of your recent cups.

Jeff Bare
Industrial Designer
@jbaredesign
Report message to a moderator
Re: Rectangular Sake & Espresso Tower Cup [message #51828 is a reply to message #51780 ] Wed, 25 July 2012 12:37 UTC Go to previous message
avatar opresco is currently offline opresco
Messages: 165
Registered: April 2010
Go to my shop
Senior Member
They are 3mm at the thinnest.

I just ordered my first test print from this series. (see link below).
I'll post the results when/if they'll print it as such.
http://www.shapeways.com/forum/index.php?t=msg&th=10169& amp;start=0&

Thanks,
Ovidiu

cascador
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Sake & Espresso Spiraling Tower Cup
Next Topic:Think Outside the Box Ring