Home » Community » It arrived! » Toroidal Half 120-Cell
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Toroidal Half 120-Cell [message #50665] Sun, 01 July 2012 07:29 UTC
avatar henryseg  is currently offline henryseg
Messages: 193
Registered: July 2008
Go to my shop
Senior Member
Toroidal Half 120-Cell is a variant on another 3D print showing a 4-dimensional polytope, Half of a 120-Cell. In both cases, printing the whole object would be very expensive, and I think it would just barely fit inside one of Shapeways' machines. So, we cut it in half. For this one, I cut it along a torus rather than a sphere.

Here's the YouTube Video.


Previous Topic:Tiny cars with open doors and turning wheels, as seen on blog.objet.com
Next Topic:Flying Pig spotted at Shapeways!