Home » Community » It arrived! » Origami Crane in FD, robotic finger in WSF
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Origami Crane in FD, robotic finger in WSF [message #50170] Fri, 22 June 2012 00:05 UTC Go to next message
avatar arklan  is currently offline arklan
Messages: 76
Registered: December 2011
Go to my shop
Member
so happy with how these turned out.

the Origami crane, wingspan 7 cm or 2.75 inches.
index.php?t=getfile&id=17790&private=0

a comparison of the printed crane to it's larger folded brother.
]index.php?t=getfile&id=17793&private=0

and a printed finger with working joints (too loose currently - will fix that later.) that's part of my attempt at a victorian prosthetic hand i found a picture of.
index.php?t=getfile&id=17792&private=0

Re: Origami Crane in FD, robotic finger in WSF [message #50191 is a reply to message #50170 ] Fri, 22 June 2012 13:18 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5105
Registered: September 2008
Go to my shop
Senior Member
I work here
The finger seems very Tim Burton esque. So the plan is a fully posable hand?


The Mad Moder
michael@shapeways.com
Re: Origami Crane in FD, robotic finger in WSF [message #50246 is a reply to message #50191 ] Fri, 22 June 2012 23:53 UTC Go to previous message
avatar arklan  is currently offline arklan
Messages: 76
Registered: December 2011
Go to my shop
Member
yup. fully poseable.

here's the inspiration: http://gizmodo.com/5626365/victorian-prosthetic-arm++no-no-n o-no-no

 
   
Previous Topic:Stampmaker
Next Topic:HandiCube by OSKAR