Home » Community » General Discussion » Modeling tolerances to get 'grip' FUD and White, Strong & Flexible?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Modeling tolerances to get 'grip' FUD and White, Strong & Flexible? [message #48863] Thu, 24 May 2012 18:22 UTC
avatar nickdk  is currently offline nickdk
Messages: 18
Registered: May 2011
Go to all my models
Junior Member
Which sizes should i model my parts to get a 'grip' as in my attached image? I need to be able to attach a small FUD part to the strong and flexible 1mm beam, and the FUD part should be attached so it can be moved up and down the beam but don't fall of if left hanging. I hope it makes sense Smile

should both parts be sized at 1mm? beam and internal gap?

  • Attachment: grip.jpg
    (Size: 72.58KB, Downloaded 48 time(s))


 
   
Previous Topic:Beer Key Fashion Pendant
Next Topic:How to produce many small identical parts - high cost?