Home » Community » 3D modeler needed » 3D Model needed for a remote control case
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
3D Model needed for a remote control case [message #48250] Fri, 11 May 2012 10:44 UTC Go to next message
avatar surendra is currently offline surendra
Messages: 1
Registered: May 2012
Go to all my models
Junior Member
Hi,

I am looking for someone who can create a 3D model for the remote control casing. This remote control is used to control Car Stereos and it will be attached to steering wheel.

Regards
Surendra
surendrai@onchiptech.com

Report message to a moderator
Re: 3D Model needed for a remote control case [message #48267 is a reply to message #48250 ] Fri, 11 May 2012 15:52 UTC Go to previous message
avatar CADNinja is currently offline CADNinja
Messages: 171
Registered: March 2012
Go to my shop
Senior Member
PM Sent

Inspire through Design, Create Solutions, Deliver on Promise
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Finishing work on a 3d model needed
Next Topic:Knife Handle