This just in from Shapeways



Can you tell what it is yet?
I'll update you later on than.
Meanwhile, a bit of praise for the people that actually do the printing at Shapeways.The item below was printed in WSF and went into the polishing machine as a single piece, but came out as three pieces as you can see.Well done for spotting that this was not a problem.This model is designed to be separated into 10 parts.



Neil.

• Attachment: may1.jpg
  (Size: 86.95KB, Downloaded 221 time(s))

• Attachment: may2.jpg
  (Size: 59.33KB, Downloaded 222 time(s))

[Updated on: Sat, 05 May 2012 21:59 UTC]

Once the parts are separated you end up with four of these.



With a few extra parts it turns into a 22 foot boxcar, ready for painting.

• Attachment: may3.jpg
  (Size: 63.55KB, Downloaded 189 time(s))

• Attachment: may4.jpg
  (Size: 60.03KB, Downloaded 189 time(s))