Home » Community » It arrived! » Mini received
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Mini received [message #46680] Mon, 09 April 2012 13:09 UTC Go to next message
avatar Kharum  is currently offline Kharum
Messages: 5
Registered: August 2008
Go to my shop
Junior Member
Good day all,
First time posting anything here. I received my second mini from shapeways the other day and to my dismay the top of the head was flat when it should have been round. I know this was a printing error because the model shows it there, the image on the site shows it there, and the first printing has it there. First question is how do I make sure this doesn't happen again? Second question is, the model looks very weak, is there a spray that I could use to strengthen it? That is all for now. Thank you ahead of time for any answers.
Kind Regards,
Kharum (Travis)
Re: Mini received [message #46681 is a reply to message #46680 ] Mon, 09 April 2012 13:12 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here

For your print, email service@shapeways.com They'll fix you up.

For strengthening it, check out the Post Production Techniques section

The Mad Moder

Previous Topic:Protoknit bangle
Next Topic:''ShapeTool'' Keychain Multitool