|Printing size and price [message #45933] Sat, 24 March 2012 21:47 UTC
Hi everyone, I need a little bit of help here.|
I just uploaded a model and I can't figure out if the size is appropriate, the numbers look good but it's a little bit too expensive and when comparing to other models I get even more confuse.
This is my model, it should be about 11 cm high(it is hollow).
But then this one is 4cm high? Isn't it to small?
Can someone tell me if I'm doing something wrong here?
[Updated on: Sat, 24 March 2012 22:21 UTC]