Home » Support » 3D Printing » How do I flag the 3D-printer operator ...
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
How do I flag the 3D-printer operator ... [message #4590] Sun, 24 May 2009 19:26 UTC Go to next message
avatar Oskar_van_Deventer  is currently offline Oskar_van_Deventer
Messages: 366
Registered: December 2008
Go to my shop
Senior Member
Hi Shapeways,

One of my puzzle designs has the property that all parts should be 3D-printed at the location where they are in the STL file. See
http://www.shapeways.com/model/31897/connectivity.html
The object of this puzzle is to move five rings from the base of the frame to the top.

I read in one of the tutorials that the operator of the 3D printer sometimes separates parts for efficiency reasons.

However, if the rings of my puzzle are 3D printed separately from their frame, one can never get them on again. So such action/error by the operator will render the puzzle useless.

How do I flag Shapeways' 3D-printer operator that he/she should not separate the parts of this puzzle?

Thank you.

Oskar

Re: How do I flag the 3D-printer operator ... [message #4591 is a reply to message #4590 ] Sun, 24 May 2009 20:02 UTC Go to previous message
avatar WiKKiDWidgets  is currently offline WiKKiDWidgets
Messages: 224
Registered: April 2009
Go to my shop
Senior Member
Send an email to Joris.

jorisATshapewaysDOTcom

 
   
Previous Topic:inverted normals 3ds Max
Next Topic:Shapeways upload filter misses overlapping pieces