| Gun barrel weight \ underlug needed [message #44329] Wed, 22 February 2012 20:21 UTC |
 |
|
|
Approximately 6inch long weight needed to be modeled to be added under a revolver pistol barrel. must be precise measurements. can send barrel to model off of.
|
|
|
| Re: Gun barrel weight \ underlug needed [message #44340 is a reply to message #44329 ] Wed, 22 February 2012 22:01 UTC |
 |
|
Sorry, i just realized a 6 inch long piece would be $300+ in stainless steel, so i am cancelling this project.
|
|
|
| Re: Gun barrel weight \ underlug needed [message #44368 is a reply to message #44340 ] Thu, 23 February 2012 12:49 UTC |
|
|
can be machined on CNC for much less
Follow me on twitter http://twitter.com/mctrivia or my blog at http://4ddice.blogspot.com/
|
|
|
| Re: Gun barrel weight \ underlug needed [message #44385 is a reply to message #44368 ] Thu, 23 February 2012 16:10 UTC |
|
|
|
do you have any suggestions for where to get this single item CNCd? thanks!
|
|
|
| Re: Gun barrel weight \ underlug needed [message #44406 is a reply to message #44329 ] Thu, 23 February 2012 23:43 UTC |
|
|
|
you might look into finding a local gunsmith. they would likely have all the tools needed for such a project
|
|
|
| Re: Gun barrel weight \ underlug needed [message #44500 is a reply to message #44406 ] Sun, 26 February 2012 13:50 UTC |
|
|
Yeah, a gunsmith is highly advised, not just for cost/experience reasons, but also safety.
http://fracturedmesh.blogspot.com/ - my 3d modeling blog
|
|
|
Search
