Home » Community » General Discussion » Non-touching parts in the design
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Non-touching parts in the design [message #43671] Wed, 08 February 2012 15:14 UTC Go to next message
avatar genekogan  is currently offline genekogan
Messages: 3
Registered: February 2012
Go to all my models
Junior Member
Hi, newbie to Shapeways here. I am working on a design for a necklace that I'd like to print and I have a basic question. Is it allowable to have no touching parts in the design get printed? My design has two interlocked loops that aren't actually one piece, like a chain link fence. If my STL file contains a small piece which is looped through the bigger one, but not actually touching it, will it get printed that way? Thanks!
Re: Non-touching parts in the design [message #43672 is a reply to message #43671 ] Wed, 08 February 2012 15:27 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5314
Registered: September 2008
Go to my shop
Senior Member
I work here
Depends on the intended material. Any of the plastics or sandstone, yes. Any of the metals, ceramic, or glass, no.


Your friendly neighborhood Moderman
michael@shapeways.com
Re: Non-touching parts in the design [message #43791 is a reply to message #43671 ] Fri, 10 February 2012 13:30 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5314
Registered: September 2008
Go to my shop
Senior Member
I work here
Correct that, ceramics you can have multiple parts. As long as each part follows the minimum size rules.

[Updated on: Fri, 10 February 2012 13:30 UTC]


Your friendly neighborhood Moderman
michael@shapeways.com

 
   
Previous Topic:Hexagon 2.5 free
Next Topic:Shops

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.