Introducing 14k Gold, read more on the blog.
Home » Community » 3D modeler needed » Help fixing a model needed.
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Help fixing a model needed. [message #43515] Mon, 06 February 2012 04:06 UTC Go to next message
avatar GalacticWierdo  is currently offline GalacticWierdo
Messages: 2
Registered: October 2010
Go to all my models
Junior Member
So I attempted recently to get a model printed, however, there were quite a few problems with it. I got attempted to get assistance from Shapeways, however, they were unable to alleviate the problem. I think that the issue here is that the model is non-manifold perhaps? But I can't find anything wrong. Any help would be appreciated!

Re: Help fixing a model needed. [message #43527 is a reply to message #43515 ] Mon, 06 February 2012 10:58 UTC Go to previous messageGo to next message
avatar stop4stuff  is currently offline stop4stuff
Messages: 3014
Registered: June 2010
Go to my shop
Senior Member
The model was missing all faces, I fixed it with NetFabb Basic by closing all holes.

The file I attached is an stl binary, let me know if you need it as .stl ascii.

Cheers,
Paul

Re: Help fixing a model needed. [message #43656 is a reply to message #43527 ] Wed, 08 February 2012 03:23 UTC Go to previous message
avatar GalacticWierdo  is currently offline GalacticWierdo
Messages: 2
Registered: October 2010
Go to all my models
Junior Member
Thank you so much for your help, it uploaded this time!

 
   
Previous Topic:Anyone willing to help with hl2 models 1:72 scale
Next Topic:Plastic Headset Prototype SketchUp on Freelancer