Home » Community » It arrived! » dog tag bone
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
dog tag bone [message #42765] Thu, 26 January 2012 00:02 UTC
avatar bvr  is currently offline bvr
Messages: 107
Registered: November 2010
Go to my shop
Senior Member
This actually cost less to print with Shapeways than if I had it done at the pet store. I think it's much nicer than the flat aluminum ones from the pet store machine too. This came out better than I was expecting but it is thin in a few spots. Perhaps too thin for dog use, time will tell. Some day I would like to get this one in stainless.
thanks for looking
feedback is always welcome
bvr







I are handsome now


 
   
Previous Topic:Cubes on a Disk by OSKAR and TONY
Next Topic:3D printed Ceramic Waterlily Soap Dish