Home » Support » 3D Printing » FUD FAIL
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
FUD FAIL [message #42298] Fri, 20 January 2012 00:45 UTC Go to next message
avatar Roy_Stevens  is currently offline Roy_Stevens
Messages: 141
Registered: November 2009
Go to my shop
Senior Member
I've always had excellent results with FUD being accurate to my model, but the most recent print I received was off more than 3%. This is a major problem for those of us building anything that interfaces with something else. Am I the only one with this issue?


Earl Grey, hot.
Re: FUD FAIL [message #42322 is a reply to message #42298 ] Fri, 20 January 2012 13:54 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5108
Registered: September 2008
Go to my shop
Senior Member
I work here
No your not the only one, I've seen this problem from time to time. As always email service@shapeways.com with you order number, some pictures and they'll get you fixed up.


The Mad Moder
michael@shapeways.com

 
   
Previous Topic:mould's and casting for silver
Next Topic:PVC/Rubber