Home » Community » 3D modeler needed » Chute modeler needed
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Chute modeler needed [message #40840] Tue, 27 December 2011 23:50 UTC Go to next message
avatar jxpx777  is currently offline jxpx777
Messages: 1
Registered: January 2011
Go to my shop
Junior Member
I need a modeler to design a chute, basically just a hollow rectangular prism but with one end shorter so that an object can be inserted:

* Internal dimensions: 25mm x 5mm
* Max external width: 32mm
* Length: 155mm but one of the long and wide faces 130mm so it's shorter than the other four faces.
* A hole in the longer of the long and wide faces so that the whole apparatus could be pinned to a cork board or similar

Imagine a straight playground slide but with a lid that's shorter than the slide to make it easier to insert the object. The hole would be under the "missing" piece of the lid so that the pin could be inserted and the back would be against the pinning surface.

I hope this makes sense...
Re: Chute modeler needed [message #40843 is a reply to message #40840 ] Wed, 28 December 2011 00:31 UTC Go to previous message
avatar mctrivia  is currently offline mctrivia
Messages: 808
Registered: September 2010
Go to my shop
Senior Member
pm sent


Follow me on twitter http://twitter.com/mctrivia or my blog at http://4ddice.blogspot.com/

 
   
Previous Topic:3 Ear of Corn
Next Topic:Modeler Needed

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.