Home » Support » 3D Printing » Earrings pair rejected for having "2 parts"
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Earrings pair rejected for having "2 parts" [message #39943] Wed, 07 December 2011 20:54 UTC Go to next message
avatar TajTiger  is currently offline TajTiger
Messages: 24
Registered: January 2011
Go to my shop
Junior Member
So, I just got a rather irritating rejection notice today.

I submitted an STL containing two identical earrings within. Today I get emails saying that the STL has been rejected with the stated reason "Multiple parts in a single STL : 2 in 1".

Now, I've read the guidelines for silver design, and I've checked the STL and sure enough, 2 shells.

What's most bothersome is that I've printed something virtually identical with a similar configuration before just fine without having to split up the STL. I don't know why one would be accepted and one rejected.

Any idea what went wrong?
Re: Earrings pair rejected for having "2 parts" [message #39944 is a reply to message #39943 ] Wed, 07 December 2011 20:55 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here
Contact service@shapeways.com, they should be able to figure out what is going on.


The Mad Moder
michael@shapeways.com

 
   
Previous Topic:Best Software to generate models for 3D color printing
Next Topic:Full validation before first purchase