Home »  » General Discussion » And yet another (couple of) DIY printer(s)
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
And yet another (couple of) DIY printer(s) [message #38702] Wed, 16 November 2011 21:00 UTC Go to next message
avatar stannum  is currently offline stannum
Messages: 899
Registered: May 2009
Go to my shop
Senior Member
Another DIY printer, with liquid material and light curing system
http://www.robhopeless.com/2011/11/laser-3d-printer-stereoli thography-at.html

Dizingof will be happy, it mentions the resins (in the Instructables BoM). Still no cheap materials.

And linked there, a second project, this one still in build phase:
http://3dlprint.com/
Re: And yet another (couple of) DIY printer(s) [message #39914 is a reply to message #38702 ] Wed, 07 December 2011 10:42 UTC Go to previous messageGo to next message
avatar 90aa749bb3  is currently offline 90aa749bb3
Messages: 1
Registered: December 2011
Go to all my models
Junior Member
It is not in the Building phase. It is past that into the testing phase.

3DLPrint
Re: And yet another (couple of) DIY printer(s) [message #39917 is a reply to message #38702 ] Wed, 07 December 2011 12:13 UTC Go to previous message
avatar dizingof  is currently offline dizingof
Messages: 1288
Registered: October 2009
Go to my shop
Senior Member
stannum wrote on Wed, 16 November 2011 21:00

Another DIY printer, with liquid material and light curing system
http://www.robhopeless.com/2011/11/laser-3d-printer-stereoli thography-at.html

Dizingof will be happy, it mentions the resins (in the Instructables BoM). Still no cheap materials.

And linked there, a second project, this one still in build phase:
http://3dlprint.com/


Wink

I actually gave him some pointers on some manufactures of low cost , low viscosity UV curing resins i tested, on that instructables page - hopefully he'll test them on his prototype.

It will take some time before we can see a DIY, resin-based 3d printer kits..
Another developer is rumored to have gone closed-source on his very anticipated 3d printer and thats too bad.
http://3dhomemade.blogspot.com/


Until then i ordered the HuxelyPro which has extremely convincing 0.1mm layer height and according to NetFabb - makers of a commercial software for these printers they can make these reprap models go even 40 or 20 micron (!) resolution... - demo of such quality can be seen on thingverse.com






[Updated on: Wed, 07 December 2011 12:18 UTC]


http://www.3Dizingof.com

 
   
Previous Topic:order overview problem
Next Topic:3D Systems Acquires ZCorp

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.