| Need Modeler for "Christmas Ornament" tpe project [message #38250] Wed, 09 November 2011 18:00 UTC |
 |
|
Looking for lightweight ball shaped open design, logo on one side and rose on other side (if possible)- "see through" hollow style and hanger/connector on top. (low definition of two sides attached). Must be clean and ready to upload to Shapeways for production as I have NO competency, just ideas. These are holiday gifts for a non-profit in 2012. SSeibert@LHS.org 
Attachment: ball.JPG
(Size: 37.95KB, Downloaded 158 time(s))
[Updated on: Wed, 09 November 2011 18:01 UTC]
|
|
|
| Re: Need Modeler for "Christmas Ornament" tpe project [message #38253 is a reply to message #38250 ] Wed, 09 November 2011 18:42 UTC |
 |
|
can not be made clear on shapeways. could be made of colored sand stone.
1 1/4" ball diameter would cost about $6 each. can make model for $15 but you need to give me proper dimensions for hanger neck as I don't have any
[Updated on: Wed, 09 November 2011 18:43 UTC]
Follow me on twitter http://twitter.com/mctrivia or my blog at http://4ddice.blogspot.com/
|
|
|
Search
