Home » Community » 3D modeler needed »

Make a Mini Samurai Helmet?

Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Make a Mini Samurai Helmet? [message #36529] Wed, 12 October 2011 18:46 UTC
avatar JSB  is currently offline JSB
Messages: 0
Registered: October 2011
Go to all my models
Junior Member
I'm looking for someone to make an ornament to fit on top of an existing belt buckle.

1) Samurai Helmet and Face Mask that resembles the attached photo.


2) A little "joiner plate" so I can put the Samurai Helmet actually on to the Air Plane Seat Belt Buckle.

The Airplane seat belt buckle is approximately a trapezoid 60 mm @ the base and 70 mm in height. Looks almost exactly like this one. http://www.skybelts.com/images/belts/skybelts_onebelt_bonzai .jpg

The ornament should be big enough to conceal it.

Thanks in advance,

  • Attachment: samurai 2.png
    (Size: 594.31KB, Downloaded 7034 time(s))

Previous Topic:Daft Punk Helmet
Next Topic:Any Good 3d Converter Software?



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.