|1st Shipment !! [message #34089] Sat, 10 September 2011 03:15 UTC
The Couplers are fantastic!|
I saw the negative gear space and thought "drat, it's too small" however I was WRONG!
It will only go on one way, and it must be STRAIGHT. , no real slop once fit and slid on.
The nut side fits the ACME 1/4" 20 Nut perfectly, no real slop once bottomed.
I may get these in Stainless...
The pliers jaw tests were cool... Not great, but cool.
These were printed just to bring the total to $25 and see a few samples.
One hole on one spreader was not there!
(No reprint needed, it printed about 5% of the depth on one side, so I will drill it)
The surface was a bit rougher that expected but it was Grey Robust. (Which files nicely I might add)
The errors in MY design were clear. Glad it was a $2.00 3D print... Sweet!
VERY happy and working on my next order.
Attachment: closup of fit.jpg
(Size: 123.30KB, Downloaded 179 time(s))
(Size: 77.73KB, Downloaded 145 time(s))
Attachment: 1st order.jpg
(Size: 92.89KB, Downloaded 144 time(s))
(Size: 90.76KB, Downloaded 105 time(s))
[Updated on: Sun, 11 September 2011 06:04 UTC]