Home » Community » Post Production Techniques » Experiences with painting "Frosted Detail" materials
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Experiences with painting "Frosted Detail" materials [message #32645] Sun, 14 August 2011 06:17 UTC Go to next message
avatar afrodri  is currently offline afrodri
Messages: 62
Registered: July 2009
Go to my shop
Member
Here is a quick experiment I did with a model printed in "Frosted Detail" – i.e. not "Frosted Ultra Detail"

http://i871.photobucket.com/albums/ab273/afrodri/HQC/VSF_tender.png

Here is the process I used:

1. I soaked it in hot water and dish soap (Palmolive Original brand) for about 10 minutes.
2. Gave it a light scrubbing with a toothbrush
3. Dried it with a paper towel and let it air dry for a few minutes
4. Gave it a light coat of grey primer (Testors light grey I believe) – I only used a light single coat, I probably would have given it a second coat, but wanted to see how it took paint.
5. Let the primer dry for a couple minutes
6. Dabbed on some paint (Vallejo 'Gory Red') (again, single coat, would have worked better with another coat or a backing coat of white)

I took the photo minutes after that, so the paint is still wet. Still, it did seem to adhere pretty well. The "feel" was right, and I think it would shape up nicely if I had taken my time. Smile
Re: Experiences with painting "Frosted Detail" materials [message #33800 is a reply to message #32645 ] Mon, 05 September 2011 10:28 UTC Go to previous message
avatar RalphVdB  is currently offline RalphVdB
Messages: 312
Registered: July 2008
Go to my shop
Senior Member
I work here
Hi Afrodri,

thank you so much for sharing this with us!


Shapeways International Customer Service Manager

 
   
Previous Topic:Plastic solvent on WSF
Next Topic:Platinum cure silicone with transparent detail